Chemical Engineering Project Topics and Full Materials for Research : Current School News

Chemical Engineering Project Topics

Welcome to TMLT Research Portal…

Feel free to browse through the ‘Chemical Engineering Project Topics‘ listed below. Click on any of the Chemical Engineering topics of your choice.

Preview the ‘Table of Content’ of the Chemical Engineering material before you order. Read the chapter one of the Chemical Engineering project material. At the end of the Chemical Engineering material’s chapter one, click on “Proceed Now to Download Page”.

Enter your contact information and email address if you want to receive any of the Chemical Engineering project materials in your email or download instantly.

WhatsApp & Contact [email protected]
08082284439
08082284439-WhatsApp
Country Code: +234
[email protected]

COMPLETE LIST OF CHEMICAL ENGINEERING PROJECT TOPICS AND THEIR RESEARCHED MATERIALS

Mathematical Modeling and Dynamic Simulation of Temperature Distribution in a Chamber Furnace

Mathematical Modeling and Dynamic Simulation of Temperature Distribution in a Chamber Furnace. ABSTRACT   Chamber furnaces are widely used in heat treatment. The correct prediction of the temperature variation and distribution within the chamber is of high significance to ensure good quality of the products being fired and reduce energy consumption. A software by trade name […]

Continue Reading »

Development of Pilot Size Process for Zeolite Y and Zsm-5 Production from Kankara Kaolin

Development of Pilot Size Process for Zeolite Y and Zsm-5 Production from Kankara Kaolin.  ABSTRACT   The successes recorded at the laboratory for the synthesis of zeolite Y and ZSM-5 using Kankara kaolin sourced from Katsina state, Nigeria as starting material necessitated the need for upscale of the production process. This thesis focused on the development of three pilot-size production units and […]

Continue Reading »

Design And Fabrication of A Fluid Catalytic Cracking Unit of A Mini Refinery

Design And Fabrication of A Fluid Catalytic Cracking Unit of A Mini Refinery. ABSTRACT Nigeria is one of the top oil-producing nations in the world but processing this oil into finished products has been a major challenge for the countries. Fluid Catalytic Cracking (FCC) Units of Nigerian Refineries produced petroleum products at far below their […]

Continue Reading »

Design of A Trunk Gas Pipeline Using Geographic Information System (Gis)

– Design of A Trunk Gas Pipeline Using Geographic Information System (Gis) – ABSTRACT Electrical energy supply has been a problem for a long time in Nigeria, especially in the Northern States where alternatives like natural gas are not available. A complete analysis of the capacity underutilization of the industries in Kano and Kaduna was […]

Continue Reading »

Depuration Studies On Kaduna Refinery Wastewater Using Modified Cu-Doped Goethite Catalyst

– Depuration Studies On Kaduna Refinery Wastewater Using Modified Cu-Doped Goethite Catalyst- ABSTRACT Undoped and copper doped goethite catalysts were synthesized and applied in the Fentondepuration of Kaduna refinery wastewater. The percentage of copper in the doped catalysts was 0.2 wt% copper in Cu-doped (A), 1.6 wt% copper in Cu-doped (B), and 3.3 wt% copper […]

Continue Reading »

Development of Pilot-scale Reactor for the Production Of Aluminium Hydroxide from Alum DerivedFrom Kankara Kaolin for Zeolite Y Synthesis 

Development 0f a Pilot-scale Reactor for the Production Of Aluminium Hydroxide from Alum Derived From Kankara Kaolin for Zeolite Y Synthesis.  ABSTRACT   This work was aimed at the design and fabrication of a pilot-scale reactor for the production of aluminium hydroxide from aluminium sulphate obtained from Kankara kaolin for use in Zeolite Y synthesis. XRD, XRF and BET analyses were carried out […]

Continue Reading »

Development of Pt-Zn/Al2o3 Catalyst for N-Octane Reforming 

Development of Pt-Zn/Al2o3 Catalyst for N-Octane Reforming. ABSTRACT  Six different platinum and zinc gamma-alumina-supported catalysts were developed by the impregnation method. Five of the catalysts consist of 1.0% wt of Zn and varying amounts of Pt (0, 0.5, 1.0, 1.5, 2.0% wt) while the sixth catalyst was chlorinated gamma-alumina, having no active metal(s) serving as the control […]

Continue Reading »

Development of Adsorbents And Photocatalysts using Nigerian Pindiga Bentonitic Clay

Development of Adsorbents And Photocatalysts using Nigerian Pindiga Bentonitic Clay. ABSTRACT The potential of Pindiga bentonitic clay for phenol adsorption from aqueous solution and photocatalytic degradation was studied. Pindiga bentonic clay was treated with oxalic acid and calcined at a temperature of 1000oC and was successfully used as an adsorbent and for the degradation of […]

Continue Reading »

Development of Zeolite Y And Zsm5 Composite Catalyst from Kankara Kaolin

Development of Zeolite Y And Zsm5 Composite Catalyst from Kankara Kaolin. ABSTRACT   Zeolite Y was synthesized from Kankara kaolin using a novel split method. The zeolite Y synthesized was thermally stabilized by impregnating with rare earth metal. Catalytic cracking catalysts; catalyst Y zeolite and catalyst Y zeolite + ZSM5 blend were formulated. The physicochemical and thermal […]

Continue Reading »

Development of Eucalpytus Tereticornis Composite (Barks And Leaves) Adsorbent for Adsorption of Chromium (Vi) and Lead (Ii) Ions from Simulated Wastewater

Development of Eucalyptus Tereticornis Composite (Barks And Leaves) Adsorbent for Adsorption of Chromium (Vi) and Lead (Ii) Ions from Simulated Wastewater. ABSTRACT   The research titled Development of Eucalyptus tereticornis composite for chromium (VI) and lead (II) ions adsorption from simulated wastewater was aimed to establish the efficacy of Eucalyptus tereticornis composite as an adsorbent applied in the adsorption of Cr6+ and […]

Continue Reading »